Settings View Source Changelog

v0-3-3-2023-01-23

v0.3.3 - 2023-01-23

changed

Changed

• Allow :vintage_net v0.13.0 to be used
• Add some more information when QMI reports no internet

v0-3-2-2022-05-02

v0.3.2 - 2022-05-02

changed-1

Changed

• :vintage_net v0.12.0 and up is now required

v0-3-1-2022-04-27

v0.3.1 - 2022-04-27

added

Added

• Add support for :roaming_allowed? field in a service provider configuration to allow or disallow roaming when using the configured service provider.

v0-3-0-2022-02-10

v0.3.0 - 2022-02-10

There was a fix that changed the property reported in the property table from "manufacture" to "manufacturer". To upgrade you will want to change any code that this is subscribe to this property to have the correct spelling.

added-1

Added

• Add support to configure which radio technologies you want the modem to use

fixes

Fixes

• References to manufacturer
• Infinite retrying to establish connection after the connection has been established
• Report selected APN before connection attempt

v0-2-14-2022-1-13

v0.2.14 - 2022-1-13

added-2

Added

• Show the configured APN in the property table

v0-2-13-2022-1-4

v0.2.13 - 2022-1-4

added-3

Added

• Allow APN selection based off ICCID when deploying SIMs from multiple service providers

v0-2-12-2021-12-20

v0.2.12 - 2021-12-20

added-4

Added

• Property named "manufacturer" for the manufacturer name of the modem
• Property named "model" for the product name of the modem

v0-2-11-2021-11-18

v0.2.11 - 2021-11-18

fixes-1

Fixes

• When there is no signal VintageNetQMI would report 1 bar of signal rather than 0 bars

v0-2-10-2021-11-17

v0.2.10 - 2021-11-17

changes

Changes

• Power manager timer was petting the watch dog every 60 miliseconds, now it will pet the watch dog every 30 seconds.
• Ignore sync indications from QMI so they are not logged.

fixes-2

Fixes

• A crash that happened when the interface would stop but there was no IP address on the interface.
• Internet connectivity checker being enabled when it should not have been

v0-2-9-2021-09-21

v0.2.9 - 2021-09-21

added-5

Added

• Property named "statistics" that contains a map of transmit and receive stats. The fields are:
  • :timestamp - monotonic time for when the stats were last updated
  • :tx_bytes - total bytes transmitted
  • :rx_bytes - total bytes received
  • :tx_packets - total packets transmitted without error
  • :rx_packets - total packets received without error
  • :tx_errors - total outgoing packets with framing errors
  • :rx_errors - total incoming packets with framing errors
  • :tx_overflows - total outing packets dropped due to buffer overflows
  • :rx_overflows - total incoming packets dropped due to buffer overflows
  • :tx_drops - total outgoing packets dropped
  • :rx_drops - total incoming packets dropped
• Property "band" for the frequency band being used by the radio interface
• Property "channel" for the channel being used by the radio interface
• Property "access_technology" for the radio interface that is active

v0-2-8

v0.2.8

• Added
  • Location and time properties:
    • lac - The Location Area Code (lac) for the current cell
    • cid - The Cell ID (cid) for the current cell
    • network_datetime - The reported datetime from the network
    • utc_offset - The UTC offset in seconds
    • roaming - If the network is roaming or not
    • std_offset - The standard offset in seconds

v0-2-7

v0.2.7

• Added

  • Support VintageNet v0.11.x
  • Serial number properties:
    • esn - Electronic Serial Number (ESN)
    • imei - International Mobile Equipment Identity (IMEI)
    • meid - Mobile Equipment Identifier (MEID)
    • imeisv_svn - IMEI software version number
  • The provider property to get the service provider name

• Fixes

  • When packet data connection is disconnected set the connection status to :disconnected
  • Check connectivity status to know if the modem should power cycle

v0-2-6

v0.2.6

• Fixes
  • Fix lease renewal ending in stuck lan connectivity

v0-2-5

v0.2.5

• Updates
  • Support qmi v0.6.0

v0-2-4

v0.2.4

• Improvements

  • Support iccid property

• Updates

  • Support qmi v0.5.1

v0-2-3

v0.2.3

• Fixes
  • VintageNetQMI.quick_configure/1 updated to use the passed in argument for the APN instead of always using hardcoded "apn" value

v0-2-2

v0.2.2

• Improvements

  • Add VintageNetQMI.quick_configure/1 to easily configure VintageNet at runtime.

• Updates

  • Support vintage_net v0.10.2
  • Better handling of connection status

v0-2-1

v0.2.1

• Updates
  • Set connection based on QMI notifications

v0-2-0

v0.2.0

• Updates
  • Change configuration to match VintageNetMobile (backwards incompatible)
  • Don't require IPv4 configuration

v0-1-3

v0.1.3

• Updates

  • Support qmi v0.3.1

• Fixes

  • Connection code blocking supervision initialization

v0-1-2

v0.1.2

• Updates
  • Support qmi v0.2.0

v0-1-1

v0.1.1

• Updates
  • Support vintage_net v0.10.0

v0-1-0

v0.1.0

Initial Release