Grizzly.ZWave.Commands.FailedNodeRemoveStatus (grizzly v0.22.3) View Source

This command reports on the attempted removal of a presumed failed node.

Params:

  • :node_id - the id of the node which removal for failure was attempted
  • :seq_number - the sequence number of the removal command
  • :status - whether the presumed failed node was removed

When encoding the params you can encode for a specific command class version by passing the :command_class_version to the encode options

Grizzly.ZWave.Commands.FailedNodeRemoveStatus.encode_params(failed_node_remove_status, command_class_version: 3)

If there is no command class version specified this will encode to version 4 of the NetworkManagementInclusion command class. This version supports the use of 16 bit node ids.

Link to this section Summary

Link to this section Types

Specs

param() ::
  {:node_id, char()}
  | {:seq_number, Grizzly.ZWave.seq_number()}
  | {:status, status()}

Specs

status() :: :done | :failed_node_not_found | :failed_node_remove_fail