View Source Grizzly.ZWave.Commands.FirmwareUpdateActivationReport (grizzly v7.4.0)

This command is used to advertise the result of a firmware update operation initiated by the Firmware Update Activation Set Command.


  • status - The status of activating the updated firmware

  • :manufacturer_id - A unique ID identifying the manufacturer of the device (required)

  • :firmware_id - A manufacturer SHOULD assign a unique Firmware ID to each existing product variant. (required)

  • :checksum - The checksum of the firmware image. (required)

  • :firmware_target - The firmware image to be updated - 0x00 for the ZWave chip, others are defined by the manufacturer (required)

  • :hardware_version - The hardware version (version 5)



@type param() ::
  {:manufacturer_id, non_neg_integer()}
  | {:firmware_id, non_neg_integer()}
  | {:checksum, non_neg_integer()}
  | {:firmware_target, byte()}
  | {:status, status()}
  | {:hardware_version, byte()}
@type status() :: :invalid_identification | :activation_error | :success