View Source Grizzly.ZWave.Commands.FirmwareUpdateActivationSet (grizzly v7.4.0)

This command is used to initiate the programming of a previously transferred firmware image.


  • :manufacturer_id - A unique ID identifying the manufacturer of the device (required)

  • :firmware_id - A manufacturer SHOULD assign a unique Firmware ID to each existing product variant. (required)

  • :checksum - The checksum of the firmware image. (required)

  • :firmware_target - The firmware image to be updated - 0x00 for the ZWave chip, others are defined by the manufacturer (required)

  • :hardware_version - The hardware version (version 5)



@type param() ::
  {:manufacturer_id, non_neg_integer()}
  | {:firmware_id, non_neg_integer()}
  | {:checksum, non_neg_integer()}
  | {:firmware_target, byte()}
  | {:hardware_version, byte()}